1-10 (No.MA341)
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
SECTION 3
DISASSEMBLY
3.1
Main body
3.1.1 Removing the FRONT PANEL assembly (See Fig.1 to
(1) From the bottom side of main body, insert the screwdriver
to hole of the third gear from hole a of the bottom chassis,
and then turn the gear to clockwise until FRONT PANEL
assembly comes up. (See Fig.1)
(2) Remove the two screws
A
attaching the both side of the
FRONT PANEL assembly. (See Fig.2)
(3) Remove the four screws
B
attaching the both side of the
FRONT PANEL assembly. (See Fig.2)
(4) Remove the one screw
C
attaching the FPC GUIDE. (See
Fig.3)
(5) Remove the one screw
D
attaching the FRONT CHASSIS.
(See Fig.3)
(6) Disconnect the card wire from MONITOR assembly con-
nected to connector
CN401
of the PANEL BOARD assem-
bly. (See Fig.4)
(7) Disengage two hooks
a
engaged FRONT CHASSIS. (See
Fig.2)
Fig.1
Fig.2
hole
a
B
B
A
A
hook
a
hook
a
