JVC GY-HM180E, Instructions Manual

Page: 31 / 194

Menu Screen
(
A
P94 [Display and Description of the Menu
Screen] )
.
Display Settings
Warnings by Lamp and Warning Tone
Warning status is indicated by tally lamp and
warning tone.
0
The tally lamp blinks.
0
Setting [Main Menu]
B
[A/V Set]
B
[Audio Set]
B
[Alarm Level] to “High” or “Low” sounds the
warning tone.
The warning tone is output from the monitor
speaker or [
x
] terminal.
(
A
P115 [ Alarm Level ] )
Memo :
0
In the event that the battery level runs low while
it is being used, the camera recorder will stop
operating automatically.
Caution :
0
The remaining battery power and time are
displayed as they are from the battery
information. Accurate data may not be displayed
depending on the battery condition. Replace the
battery as soon as possible when the remaining
battery power and time are low.
Turning On/Off the Power
Turning On the Power
1
Hold down the lock button (blue) at the
center of the [POWER ON/OFF] switch to set
to “ON”.
The camera recorder starts up in Camera mode
and is ready for shooting.
Memo :
0
The camera recorder always start up in Camera
mode when the [POWER ON/OFF] switch is set to
“ON”. Use the [MODE] button at the side of the
camera recorder to switch mode.
(
A
P18 [Operation Modes] )
0
If the battery is not fully charged, the battery will be
charged at the same time.
0
Even when a fully charged battery is used, charge
the battery briefly to confirm the remaining battery
power.
(
A
P29 [Power Supply] )
(
A
P31 [Power Status Display] )
.
Turning Off the Power
Sets the camera recorder to the recording standby or
stop mode.
1
Hold down the lock button (blue) at the
center of the [POWER ON/OFF] switch to set
to “OFF”.
2 Remove the battery and the power to the [DC]
terminal (when not in use for a long time).
Caution :
0
Do not set the [POWER ON/OFF] switch to “OFF”
during recording. Check that the operation mode
display is “STBY” or “STOP” before you turn off the
power.
0
If you have mistakenly set the [POWER ON/OFF]
switch to “OFF” during recording, wait for 5
seconds or more before you turn on the power
again.
0
When turning off the power, first set the [POWER
ON/OFF] switch of the camera recorder to “OFF”.
Do not remove the battery or turn off the AC power
while the [POWER ON/OFF] switch is set to “ON”.
32
Power Status Display
Pr
ep
ar
ati
ons