31
Set the [ND FILTER] switch to
Reduces the amount of incident light to 1/10.
appears on the screen.
Memo :
●
Enabling [ND FILTER] during shooting may cause
distortion in the image or noise in the audio sound.
Applicable to: Full Auto shooting mode
A
, Manual shooting
mode
M
Generally, the brightness of the subject that is being shot is
automatically adjusted according to the reference values of the
camera. However, the brighter or darker areas of an image may
appear unclear depending on the shooting conditions. To prevent
this from occurring, you can correct the exposure manually.
1
Set to the Manual Exposure mode.
●
●
The AE value appears on the screen, and the adjustment
mode is enabled.
2
Adjust the exposure.
●
Operate with the [ADJ./VOL.] knob.
●
Tilt upward to increase the value and make the image brighter.
●
Tilt downward to decrease the value and make the image
darker.
3
Confirm the setting value.
●
Press the [ADJ./VOL.] knob.
●
The manual setting value is set.
(The setting value (-6 to +6) is displayed on the screen.)
4
After setting the value, press the [ADJ./VOL.] knob for
1 second or longer to switch to the AE Lock mode.
●
An
L
mark appears after the setting value on the screen.
●
AE Lock: Locks the exposure setting value.
Canceling AE Lock
1
Press the [ADJ./VOL.] knob for 1 second or longer.
The mark disappears.
Disabling the Manual Exposure mode
1
Memo :
●
AE lock cannot be canceled in the following cases.
•
When the shutter speed or aperture is set to the manual
mode
•
When a setting other than
•
When a setting other than the entire screen is selected
in [AE Area](
•
When switched to the Full Auto/Manual mode
Adjusting the Exposure
Manually
AE
AE Value
ADJ
./V
OL
ADJ
./V
OL
AE Lock
ADJ
./V
OL
AE
DC
OPEN
REC
PUSH
OI
S
SHUTTER
AE
±
ADJ
./ V
O
L.
CLOSE
ACCESS
CAM
MEDIA
[ADJ./VOL.]
Knob
GY-HM150U.book Page 31 Monday, September 5, 2011 1:48 AM
