JVC GR GR-DV4000, Instructions Manual

Page: 71 / 88

EN
71
Master Page: Right
Other problems
24. Although Snapshot is
attempted, flash does not take
place. 24. • The subject is too bright with
the flash set to “AUTO” or
“AUTO
C ”.
• If blinks, the flash is being
charged.
• The camcorder is in the
Record mode.
24. • Set “B-IN FLASH” to “ON”
in MANUAL Menu.
(
墌
pg. 31, 37)
• It can take up to 10 seconds
to charge the flash.
• Set the camcorder in the
Record-Standby mode.
(
墌
pg. 42, 43)
25. Although a Snapshot is taken
with the flash, Red-Eye
Reduction does not take place. 25. • The subject does not look
straight toward the flash.
• The subject does not look at
the first flash, which is an
important part of Red-Eye
Reduction.
• The camcorder is too far
from the subject.
• In MANUAL Menu, “B-IN
FLASH” is not set to
“AUTO
C
”.
25. • The subject should look
straight toward the flash,
especially the first flash. If
the subject does not see the
first flash, it will be difficult
for Red-Eye Reduction to
take place. (
墌
pg. 43)
• The flash is effective for
subjects at a distance of
approx. 0.7 m to 2 m from
the camcorder. (
墌
pg. 43)
• Set “B-IN FLASH” to
“AUTO
C
” to display the
Red-Eye Reduction indicator.
(
墌
pg. 31, 37)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
26. The CHARGE indicator on the
AC Power Adapter/Charger
does not light. 26. • The temperature of the
battery is extremely high/low.
• Charging is difficult in places
subject to extremely high/
low temperatures.
26. • To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C. (
墌
pg. 74)
27. “SET DATE/TIME!” appears. 27. • The built-in clock’s
rechargeable lithium battery
is discharged.
• The previously set date/time
is erased.
27. • Connect the camcorder to an
AC outlet using the AC Power
Adapter/Charger for over 24
hours to charge the clock’s
lithium battery. (
墌
pg. 14)
28. There is no picture. 28. • The camcorder is not getting
power, or some other
malfunction exists.
28. • Turn the camcorder’s power
off and on again. (
墌
pg. 13)
29. Some functions are not
available using the
MENU
Wheel.
29. • The Power Switch is set to
“
A
”.
29. • Set the Power Switch to “ M ”.
(
墌
pg. 13)
30. Files stored in the memory
card cannot be deleted. 30. • Files stored in the memory
card are protected.
30. • Remove protection from the
files stored in the memory
card and delete them.
(
墌
pg. 27 –28)
31. When the image is printed
from the printer, a black bar
appears at the bottom of the
screen. 31. • This is not a malfunction. 31. • By recording with “DIS”
activated (
墌
pg. 31, 35) this
can be avoided.
RE
FERENCES
CONTINUED ON NEXT PAGE
GR-DV4000PAL.book Page 71 Friday, February 14, 2003 10:30 PM