62
EN
EDITING
You can use a camcorder as the source player and your unit as the
recording deck.
1
Make connections.
A
If the camcorder has no S-VIDEO output connector:
^
connect the camcorder’s AUDIO/VIDEO OUT connectors to
the unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors
on the front panel.
●
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B
If the camcorder has an S-VIDEO output connector:
^
connect the camcorder’s AUDIO OUT and S-VIDEO OUT
connectors to the unit’s [AUDIO] and [S-VIDEO] input
connectors on the front panel.
2
Press
HDD
or
DVD
to select the recording deck.
3
Press
PR +/–
to select
A
F-1
B
.
●
Set
A
F-1 INPUT
B
to
A
VIDEO
B
for the [VIDEO] input connector,
or
A
S-VIDEO
B
for the [S-VIDEO] input connector, depending on
the connector being used. (
A
pg. 65)
4
Press
REC MODE
repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press
R
on the unit to start recording. Or while holding
R
, press
I
on the remote control. The dubbing starts.
7
Press
o
on the unit, then stop playback on the camcorder.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
Refer to the camcorder’s instruction manual for operating
procedure.
●
The quality of dubbed picture becomes poorer than that of the
original.
Edit From A Camcorder
A
If the camcorder has no S-VIDEO output connector:
Recorder
Player
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
AUDIO/VIDEO OUT
B
If the camcorder has an S-VIDEO output connector:
To [S-VIDEO] input
S-video cable
(not supplied)
AUDIO OUT
Audio cable
(not supplied)
S-VIDEO OUT
Recorder
Player
To [AUDIO]
input
●
Slide the
TV/CABLE/SAT/DVD
switch to
DVD
.
