Masterpage:Right+
61
Filename [DX5SEU_12Editing.fm]
EDITING
Page 61
Wednesday, 23 November 2005 14:13
You can use a camcorder as the source player and your unit as the
recording deck. If your camcorder has a DV IN/OUT connector, you
can use the camcorder as the recording deck and your unit (DV
deck only) as the source player.
1
Make connections.
A
If the camcorder has no S-VIDEO output connector:
^
connect the camcorder’s AUDIO/VIDEO OUT connectors to
the unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors
on the front panel.
●
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B
If the camcorder has an S-VIDEO output connector:
^
connect the camcorder’s AUDIO OUT and S-VIDEO OUT
connectors to the unit’s [AUDIO] and [S-VIDEO] input
connectors on the front panel.
C
If the camcorder has a DV IN/OUT connector:
^
connect the camcorder’s DV IN/OUT connector to the unit’s
[DV IN/OUT] connector.
●
When using your unit as the source player, refer to the
camcorder’s instruction manual for the recording procedure.
2
Press
on the unit repeatedly to select
the recording deck.
3
Press
●
Set
for the [VIDEO] input connector,
for the [S-VIDEO] input connector, depending on
the connector being used. (
4
Press
repeatedly to set the recording mode. For
DV deck, press
on the remote control to set the
recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press
on the unit to start recording. Or while holding
on the remote control. The dubbing starts.
7
Press
on the unit, then stop playback on the camcorder.
●
All necessary cables can be obtained from your dealer.
●
Refer to the camcorder’s instruction manual for operating
procedure.
●
The quality of dubbed picture becomes poorer than that of the
original.
●
When you are editing through the [DV IN/OUT] connector, the
unit will stop if the player begins playing a blank portion of tape or
the signal is interrupted.
●
When connecting the unit to a device equipped with a DV input
connector, be sure to use the optional DV cable (VC-VDV 204U).
●
To edit through the [DV IN/OUT] connector using the HDD or
DVD deck, refer to
DV Dubbing (HDD & DVD Deck Only)
Edit From A Camcorder
A
If the camcorder has no S-VIDEO output connector:
Recorder
Player
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not supplied)
B
If the camcorder has an S-VIDEO output connector:
To [S-VIDEO]
input
To [AUDIO] input
S-video cable
(not supplied)
Audio cable
(not
supplied)
Recorder
Player
C
If the camcorder has a DV IN/OUT connector:
To [DV IN]
DV cable
(VC-VDV 204U)
(not supplied)
DV connector
Player/Recorder
Recorder/Player
●
Slide the
switch to
DX5SEU_00.book Page 61 Wednesday, November 23, 2005 2:13 PM
