JVC DR-DX5SE, Instructions Manual

Page: 39 / 92

Masterpage:Right0
EN
39
Filename [DX5SEU_08DV Operation.fm]
Page 39Wednesday, 23 November 2005 14:13
BASIC OPERATIONS ON DV DECK
1
Load a cassette. Make sure the window side is up, the rear
label side is facing you and the arrow on the front of the
cassette is pointed toward the unit.
●
Do not apply too much pressure when inserting.
●
If the erase protection switch is set to A SAVE B , playback begins
automatically. It takes about 15 seconds until the playback
picture appears. However, when
A POWER SAVE B is set to
A ON B (
A
pg. 73), playback will not begin automatically even
though a cassette with its erase protection switch set to
A SAVE B is inserted.
●
The unit’s power comes on automatically.
2
Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
the remote control so that the DV lamp lights up on the unit.
3
Find the programme start point. If the tape is advanced past the
start point, press
O
. To go forward, press
N
.
4
Press
I
to start playback.
5
Press
o
to stop playback.
●
To eject the cassette, press
M
(DV).
NOTES:
●
This unit does not support playback of DV tapes with HD format
recordings.
●
When you record a tape on the DV deck with the recording speed
set to
A LP B , it is recommended to play back that tape back on this
DV deck. Digital video recorder from other manufacturers may not
be able to play back the tape properly.
●
It is possible to play back on the DV deck and the HDD/DVD deck
simultaneously. However, either DVD or HDD can be played at
the same time.
Basic Playback
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD .
DV/HDD/DVD
SELECT
I
M o
O
N
DV
o
N
O
I
CABLE/SAT
DVD TV
DV lamp
Clean the video heads using a dry cleaning cassette
- M-DV12CL - when:
●
No picture during playback.
●
Block noise appears during playback.
●
A USE CLEANING CASSETTE B appears on the screen.
NOTE:
The heads get dirty in the following cases:
●
in an environment prone to extreme temperature or humidity
●
in a dusty environment
●
flaw, dirt or mould on video tapes
●
continuous usage for a long time
Usable cassettes
●
Cassettes marked
P
can be used with the DV deck.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette, set its
erase protection switch to
A
SAVE
B
. To record on it later, set the
switch to A REC B .
Erase protection switch
DX5SEU_00.book Page 39 Wednesday, November 23, 2005 2:13 PM