IP Address Settings
Set the IP address for this projector. There are 2 methods to set the IP address.
0
Assigning a static IP address
0
Assigning IP Address from the DHCP Server
Assigning a static IP address
The “IP Address Setting” of this projector is set to “STATIC IP” (the DHCP client function is OFF) by default.
Upon turning on the power, this projector starts running with the following IP address.
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.0.254
IP address setting at the computer
Set the computer to an IP address that enables communication with this projector.
1
Click “Start” and select “Control Panel”
2
Double click “Network Connections”
3
Right-click on “Local Area” and select “Properties”
0
Check to ensure that the “Client for Microsoft Networks” and “Internet Protocol(TCP/IP)” check boxes are
selected.
4
Select “Internet Protocol(TCP/IP)” and click “Properties”
5
Set the IP address
A
Select “Use the following IP address”
B
Set “IP address”
(For example, use 192.168.0.100 when DLA-VS4010 /
DLA-VS4810 is in its default settings)
MEMO
0
Make sure that you take note of the original IP
address before altering.
0
When setting, ensure that a duplicate IP address is
not used within the same network environment.
C
Set “Subnet mask”
Set to a value that is appropriate for the setting operation.
Clarify with the network administrator if you have any
queries.
(Use 255.255.255.0 when the camera is in its default
settings)
D
When a “Default gateway” is present, make use of the IP
address (e.g., 192.168.0.254)
E
Click “OK”
6
Click “OK” on the “Local Area Connection Properties” screen
A
B
C
D
E
25
Network Settings