JVC DLA-HD10KSU/E, Instructions Manual

Page: 38 / 50

Replacing the Lamp (continued)
38
a
Insert plug into the power outlet
●
The main power turns on and the [STAND BY] indicator on the unit lights
up.
b
Press the [EXIT], [ENTER] and [HIDE] buttons
sequentially, then press the [
K
] button for 2
seconds or more
●
The [STAND BY] and [OPERATE] indicators will alternately blink for a
duration of about 3 seconds each. After blinking stops, lamp time resets
and the unit returns to the standby mode ([STAND BY] indicator lights
up).
Resetting Lamp Time
After installing a new lamp (lamp unit), reset the lamp time. The lamp time counter will be reset and a new count will
start.
●
If the accumulated lamp time has reached 2000 hours, this unit will not work (lamp does not light up) unless the lamp time is
reset.
ON
ENTER
OFF
CHP TEST
MENU EXIT
LIGHT
OPERATE
HIDE PRESET
ZOOM
T
W
FOCUS
EXIT
ENTER
HIDE
K
To ensure the lamp time has been reset
The lamp time can be checked via the
A
Lamp Time
B
item of the
A
Information
B
menu. (
A
Pages 28, 32)
Caution During Reset Work
Reset the lamp time only when you have replaced the lamp.
Never reset it when the lamp is still in use.
Otherwise, the approximate standard for gauging replacement time may be
inaccurate, lamp performance may deteriorate and lamp blowout may
occur.
EXIT
ENTER
HIDE
Press as per normal
Press for 2 seconds or more
DLA-HD10_EN-FR.book Page 38 Thursday, November 10, 2005 12:54 PM
Downloaded from ProjectorsManual.com Manuals