Function
Trigger
For configuring 12 V output to an external screen equipped with a trigger function.
Setting
Description
Off
No output.
On (Power)
Outputs control signals (12 V) from the trigger terminal when the power is turned
on.
0
After the power is turned off, output stops when the unit shifts to the Standby
mode after cooling is complete.
0
You can also output signals in the Standby mode by pressing the [OK] button.
On (Anamo)
Outputs control signals when the “Anamorphic” setting is switched from “Off” to “A”
or “B”.
Off Timer
For setting the timing to power off the unit automatically (“1 Hour”, “2 Hours”, “3 Hours”, or “4 Hours”) when it is not
operated for a period of time.
High Altitude Mode
Set to “On” when using the projector at a location of low atmospheric pressure (higher than 900 m above sea level).
ECO Mode
Setting
Description
On
Minimizes power consumption in the Standby mode.
0
If there is no signal transmission or operation for 30 minutes while an image is
projected, the power is turned off automatically.
Off
Set to “Off” if RS-232C / LAN communication is performed or the HDMI link function
is used in the Standby mode.
Communication Terminal
For setting the external control terminal to be used to “RS-232C” or “LAN”.
Network
Setting
Description
DHCP Client
On
Obtains the IP address automatically from the DHCP server inside the connected
network.
Off
For configuring the network settings manually.
IP Address
For configuring the IP address.
Subnet Mask
For configuring the subnet mask.
Default Gateway
For configuring the default gateway.
MAC Address
Displays the MAC address of the unit.
Set
Applies the network settings.
62
Adjust/Set
