Setting Time Code without Opening the
Menu
.
PRESET
TC
F-RUN
R-RUN
REGEN
UB
GEN
DISPLAY
Memo :
0
Settings cannot be made in the following cases.
0
When the [TC GEN] switch is set to
“REGEN”.
0
Menu screen is displayed.
0
The camera recorder is not in the Camera
mode.
Setting Time Code
1
Set the [TC DISPLAY] switch to “TC”.
2
Set the [TC GEN] switch to a setting other
than “REGEN”.
3
Press the [TC PRESET] button.
.
4
Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (
HI
) to place the
cursor at the item to set, then use the cross-
shaped button (
JK
) to change the values.
Memo :
0
Press the [CANCEL/RESET] button to reset
each digit to “0”. The cursor moves to the left.
5
Check the values and press the Set button
(
R
).
0
The time code is set and the screen returns
to the normal screen.
0
To cancel the setting, press the [TC
PRESET] button.
Caution :
0
When the camera recorder is switched to Media
mode during editing, editing will be canceled
and the screen will close.
0
When editing the time code, operations of the
buttons configured in [Camera Function]
B
[User Switch Set] are disabled.
Recording Time Code in Continuation of
the Recorded Time Code on SD Card
This camera recorder is equipped with the time
code reader.
1
Set the [TC GEN] switch to “REGEN”.
0
When the camera recorder enters from
recording standby mode to recording mode,
it reads the time code already recorded on
the SD card and records the new time code
in continuation of that value.
0
The same data as the user’s bit already
recorded on the SD card is recorded.
Memo :
0
When the [TC GEN] switch is set to “REGEN”,
the framing mode of the time code follows the
settings in [TC/UB]
B
[Drop Frame] instead of
the clip settings.
76
Setting Time Code Generator
Sh
ooting
Summary of Contents for Connected Cam GY-HC900CHE
Page 2: ...2 ...
