14
Using the Tuner
English
●
Preset Tuning using the Remote Control
(Possible only after presetting stations)
Select the desired preset number using the
3
or
2
button on the Remote Control. The display will show
the preset number’s band and frequency.
• You can also select the desired preset number
using the Numeric Keys. See “Entering the
Number with the Remote Control” on page 12.
(e.g. Press +10, and then 2 for number 12.)
Example:
Press the
3
button until the preset number “2” ap-
pears.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM sta-
tions.
• Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.
On the Remote Control
1
Select a band by pressing the FM/AM
button.
2
Press the
5
or
∞
button to tune in a sta-
tion.
3
Press the SET button.
Preset number “1” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
4
Press the Numeric Keys, or the
3
or
2
button within 5 seconds to select the
preset number.
Example:
5
Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6
Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations,
repeat the same
steps as above.
CAUTION:
• Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
To Change the FM Reception
Mode
When you are tuned into an FM stereo broadcast, the “ST.”
indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
FM AUTO mode is also useful to suppress static noise be-
tween stations.
To enter Monaural mode while receiving an FM
broadcast,
press the FM/PLAY MODE button on the Re-
mote Control until “FM MONO” appears on the display. Then,
the “MONO” indicator lights up.
Each time you press the FM/PLAY MODE button, the display
alternates between “FM AUTO” and “FM MONO”.
To restore the stereo effect,
press the FM/PLAY
MODE button on the Remote Control until “FM AUTO” ap-
pears on the display. Then, the “MONO” indicator goes out
and the “ST.” indicator will light up.
DOWN
UP
3
3
Preset number
or
SET
+10
1
STORED
2
SET
FM / AM
When changing the Band
FM = 30, AM = 15
or
FM/PLAY
MODE
FM AUTO
Ô
FM MONO
FS-X1-3(US)_E.book Page 14 Friday, April 18, 2003 7:27 PM
