JVC CA-DXJ11, Service Manual

Page: 23 / 91

(No.MB666<Rev.005>)1-23
3.2.10 Removing the feed motor
(See Figs.18 and 19)
• Remove the tray assemblies and DVD traverse mechanism
assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the screw K attaching the feed bracket and re-
move the feed bracket from the sections t . (See Fig.18.)
(2) Release the claw u of the thrust spring in the direction of
the arrow and remove the thrust spring. (See Fig.18.)
(3) Remove the screw shaft from the section v and remove it
in the direction of the arrow. (See Fig.19.)
(4) Remove the middle gear. (See Fig.19.)
(5) Remove the screw
L attaching the feed motor to the C.TM
chassis. (See Fig.19.)
(6) Remove the wires from the soldered sections w on the
spindle motor board. (See Fig.19.)
(7) Take out the feed motor from the motor base.
Reference:
After attaching the feed motor, pass the wires through the sec-
tions
x on the C.TM chassis as before. (See Fig.19.)
Fig.18
Fig.19
Thrust spring
Thrust spring
K
t
u
Feed bracket
Spindle motor board
Screw shaft
Middle gear
C.TM chassis
v
x
w
L