Juplink RX4-1800, User Manual

Page: 42 / 65

42
8.7. Mesh
Mesh connection mode can be quickly achieved via WPS button
1) Connect your router’s WAN port to the LAN port of the modem or another router (main
router).
2) Set up the router whose WAN port is connected, enable it to access the Internet normally
(please note that the wireless network must be set to the properly encrypted state and
password has been set).
4) Press the WPS button on both routers/modem for at least 5 seconds.
5) After about 30 seconds until the lights on both routers/modem change from flashing to
steady green, the setting is complete. By now the mesh network is established and can be
used normally.
Note:
-If you want to continue adding mesh devices, get another RX4-1500 router to build the
mesh network. Press the WPS button on the new device and the main router in the mesh
network for at least 5 seconds, and wait for the mesh network to complete.
-Devices that log in through the mesh network can only access the main router and view sub
devices in
Advance > Mesh .
-If failed, please reset both routers/modem and follow the setting steps again.
Mesh status display
1) After
pressing the WPS button on the main router for at least 5 seconds. Mesh page is
displayed as follows: (no following router is connected yet)
Role: Controller
Status: Waiting for pairing