JA10-070 Audio Controller - Ten Transceiver with RX Volume Control
Installation and Operating Manual
Rev A
Page 18
(1)
Transceiver receive audio select switches, TX select annunciators and associated
legends
These are ten white two-position toggle switches positioned round the TX selector control
(6)
.
Legend
TX select annunciator
TX select switch
(2)
Individual RX Volume Control
Each of the COM radios (COM 1 – COM 9) has an individual
RX
volume control knob (2)
above it.
Rotating the knob clockwise (CW) will increase the volume for that specific COM radio, and rotating it
counterclockwise (CCW) will reduce the volume.
(3)
Receiver audio select switches and associated legends
These are two blue three-position centre-off
toggle switches. When the switch is set to the
‘up’ or ‘down’ position towards a legend, audio
from the selected receiver is routed to the
phones.
The legends may be ordered with custom
markings to match aircraft radio nomenclature.
(
Default
–
NAV1
,
NAV2
,
ADF1
and
ADF2
.)
(4)
Master Receive Volume Control
This is a rotary knob that adjusts the phones volume of all receive
audio from minimum (rotated fully CCW) to maximum (rotated
fully CW). This control should be set to a nominal level, and then
the individual radio volume controls adjusted for changing flight
conditions.
•
The
legends
may be ordered with custom markings to match
aircraft radio nomenclature. (
Default
:
COM1
to
COM9,
and
AUX
.)
•
When a
switch
is set to the ‘up’ position, audio from the
associated transceiver is routed to the phones, and the triangular
annunciator
will illuminate green to indicate the selected COM
radio.
