JUNO JKI 2038 Operating Instruction Download Page 7

Positioning

¥ Unpack the cabinet and check that it is in good

condition and free of any transport damage.

¥ Place the refrigerator away from direct sunlight and

heat sources.

¥ Avoid prolonged exposure of the appliance to

direct sunlight.

¥ For safety reasons, minimum ventilation must be

as shown in Fig.

Attention: keep ventilation openings clear of
obstruction.

¥ It is necessary that the niche is provided with a

conduct of ventilation having the following
dimensions:
Depth 50 mm
Width 540 mm

16

Installation

Take utmost care when handling your
appliance so as not to cause any damages to
the cooling unit with consequent possible fluid
leakages.

¥ During normal operation, the condenser and

compressor at the back of the appliance heat up
considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.

¥

Important:

if the supply cord is damaged, it must

be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.

50 mm

min.
200 cm

2

200 cm

2

min.

D526

Technical specifications

The technical data is indicated in the rating plate on the left side inside the appliance.

This information can be found on the rating plate
inside the cabenit on the left hand wall. We
recommend that you enter this information here, so
that it is handy if needed.

If you cannot find the remedy for a malfunction in
these operating instructions, please contact your
dealer or our customer service department and
consult the Guarantee card.
Selective ordering of replacement parts can save
unnecessary travel and costs.
For this reason always provide the following
appliance information:

¥ 

Model Name

¥ 

Model Number (PNC)

¥ 

Serial Number (S-No.)

Customer service and spare parts

The climate classification can be found on the rating
plate, which is located inside the cabinet on the left
hand wall.

The following table shows which ambient
temperature is correct for each climate classification:

Climate
classification

SN

+10 to +32¡C

+16 to +32¡C

+18 to +38¡C

+18 to +43¡C

N

ST

T

for an ambient temperature of

Summary of Contents for JKI 2038












Reviews: