SAVE THESE INSTRUCTIONS
WARRANTY
Juno Lighting Group warrants that its LED step light products are free from defects in material and workmanship for three years
from date of purchase. Juno Lighting Group’s obligation is expressly limited to repair or replacement, without charge, at Juno Lighting
Group’s factory after prior written return authorization has been granted. This warranty shall not apply to products which have been
altered or repaired outside of Juno Lighting Group’s factory. This warranty is in lieu of all other warranties, expressed or implied, and
without limiting the generality of the foregoing phrase, excludes any implied warranty of merchantability. Also, there are no warranties
which extend beyond the description of the product on the company’s literature setting forth terms of sale.
1300 South Wolf Road • Des Plaines, IL 60018
PHONE (847) 827-9880 • FAX (847) 827-2925 • www.junolightinggroup.com
© 2010 Juno Lighting LLC Rev 4/10 P2858 pg 1 of 1
INSTALLATION INSTRUCTIONS
JUNO TYPE IC OUTDOOR STEP LIGHT - IC115LED
WARNING:
For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE:
Juno recessed fixtures are designed to meet the latest NEC requirements and are listed in full compliance
with UL 1598. Before attempting installation of any recessed lighting fixture, check your local electrical building code.
This code sets the wiring standards and installation requirements for your locality and should be understood before
starting work. Use of non-Juno trims voids Juno warranty.
9”
4 1/8”
3”
Product Information
IC115LED Outdoor Step Light is modular in design allowing the
back housing to ship separate for rough-in purposes.
(3) Three components are needed for complete fixture:
Housing Installation
IC rated fixture suitable for installation in outdoor or indoor wall
mount applications including concrete pour, brick masonry or
drywall. Can be completely covered with insulation.
Note:
Housing should be flush to finished wall to ensure seal.
Step 1.
Install housing in opening using adjustable
housing brackets. Attach brackets to mounting surface using
appropriate screws (not supplied).
Step 2.
Provide electrical service according to your local
electrical code to the housing. Supply wire insulation must be
rated for at least 90°C.
Step 3.
Connect ½” conduit to fittings provided on housing.
Make certain unused fittings are sealed with the conduit fitting
plug provided.
Step 4.
Remove weather cover from housing. Pull supply
wires into housing. If ready to install power module and trim
(sold separately), proceed to step 5. If not, replace weather
cover to protect fixture until ready for power module & trim
installation.
Required opening for installation – 3” x 9” x 4-1/8” deep.
Weather Cover
Housing
Conduit
Fitting
Plug
Adjustable
Housing Bracket
Power Module
Leads
Power Module
(sold separately)
Trim
(sold separately)
+
+
IC115LEDHSG
Back Housing with
Cover Plate
IC115LEDPM-3K
IC115LEDPM-41K
Power Module Tray
with LED Driver & PCB
835, 836, 837
Trim
Note: IC115LEDPM only for use with IC115LEDHSG
Power Module Installation
Step 5.
Connect supply wires to leads on power module
(Black-to-black, White-to-white) with proper size wire nuts (not
supplied), so as to cover all bare current carrying conductors.
Connect supply ground wire (if applicable) to green ground
wire inside housing.
Step 6.
Mount power module to housing using screws
provided with housing.
Trim Installation
Step 7.
Wipe housing gasket clean to ensure a proper
trim seal.
Step 8.
Install trim using allen-head screws supplied with trim.
Lens must be properly sealed against housing gasket to seal
out moisture.
Trim Mounting
Screws
Power Module
Mounting Screws
