Related
Documentation
Installing the WLA532 Access Point on a Suspended Ceiling Rail on page 33
•
Connecting the Access Point to Wireless LAN Controllers
You can connect a wireless LAN access point to a Wireless LAN controller (WLC) directly
or indirectly through an intermediate layer 2 or layer 3 network.
To connect the access point directly to a WLC:
1.
Insert one end of a Category 5 cable with a standard RJ-45 connector to the ethernet
port of the access point and the other end to ethernet port of the controller. For
connection to an access point, use a straight-through signaling cable.
2.
Observe the access point LED for the port on the controller.
The link is activated if the LED is green and glowing steadily.
To configure the access point connection, use the RingMaster GUI or the Mobility System
Software CLI.
If you are installing the access point in a Wireless LAN mesh or wireless bridge
configuration, you must configure the access point connection before deploying the
access point in the final location. For more information, see the Mobility System Software
Configuration Guide or the Configuration Guide.
Related
Documentation
•
Mobility System Software Configuration Guide at
.
39
Copyright © 2011, Juniper Networks, Inc.
Installing the Access Point
Summary of Contents for WLA532
