Juniper TCX1000-RDM20, Hardware Manual

Page: 77 / 206

Before You Begin Mounting the TCX1000-RDM20
Before you begin mounting a TCX1000-RDM20 in the rack:
1.
Ensure that you understand how to prevent electrostatic discharge (ESD) damage.
See
“Prevention of Electrostatic Discharge Damage” on page 178 .
2.
Verify that the site meets the requirements described in “TCX1000-RDM20 Site
Preparation Checklist” on page 29 .
3.
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
4.
Read “General Safety Guidelines and Warnings” on page 153 , and “Installation
Instructions Warning” on page 159 .
5.
Remove the TCX1000-RDM20 from the shipping carton (see “Unpacking the
TCX1000-RDM20” on page 61 ).
6.
Ensure that you have the following parts and tools available to mount the
TCX1000-RDM20 in a rack:
• ESD grounding strap (not provided).
• Eight self-tapping 10-32 bolts to secure the chassis and mounting brackets to the
rack (provided).
•
19-in. mounting brackets (attached to the chassis).
• (Optional) 21-in. and 23-in. mounting brackets (provided).
• Screwdriver appropriate for the rack mounting screws (not provided).
CAUTION: If you are mounting multiple devices in a rack, mount the device
in the lowest position of the rack first. Proceed to mount the rest of the devices
from the bottom to the top of the rack to minimize the risk of the rack toppling.
63 Copyright © 2019, Juniper Networks, Inc.
Chapter 11: Unpacking and Mounting the TCX1000-RDM20