Juniper SSG 20-WLA, Hardware Installation And Configuration Manual

Page: 45 / 82

Mini PIM Configuration
„ 35
set interface bri1/0 ppp profile isdnprofile
save
For more information on how to configure the ISDN interface, refer to the Concepts
& Examples ScreenOS Reference Guide .
To configure the ISDN interface as the backup interface, see “Backup Untrust
Interface Configuration” on page 26.
The T1 Interface
The T1 interface is a basic Physical Layer protocol used by the Digital Signal level 1
(DS-1) multiplexing method in North America. A T1 interface operates at a bit-rate
of 1.544 Mbps and can support 24 DS0 channels.
The devices support the following T1 DS-1 standards:
„ ANSI TI.107, TI.102
„ GR 499-core, GR 253-core
„ AT&T Pub 54014
„ ITU G.751, G.703
To configure the T1 mini PIM, do either of the following:
WebUI
Network > Interfaces > Edit (interface) > WAN: Enter or select the applicable
option value, click
OK .
WAN Configure: main link
WAN Encapsulation: cisco-hdlc
Zone Name: untrust
IP Address/Netmask 172.18.1.1/24
CLI
set interface serial1/0 encap cisco-hdlc
set interface serial1/0 ip 172.18.1.1/24
For information on how to configure the T1 interface, refer to the Concepts &
Examples ScreenOS Reference Guide .