Juniper SSG 20-WLA, Hardware Installation And Configuration Manual

Page: 34 / 82

SSG 20 Hardware Installation and Configuration Guide
24 „
Basic Device Configuration
Setting the Date and Time
The time set on an SSG 20 device affects events such as the setup of VPN tunnels.
The easiest way to set the date and time on the device is to use the WebUI to
synchronize the device system clock with the workstation clock.
WebUI
1. Configuration > Date/Time: Click the Sync Clock with Client button.
A pop-up message prompts you to specify if you have enabled the daylight
saving time option on your workstation clock.
2. Click Yes to synchronize the system clock and adjust it according to
daylight saving time or click No to synchronize the system clock without
adjusting for daylight saving time.
You can also use the
set clock
CLI command in a Telnet or Console session to
manually enter the date and time for the SSG device.
Bridge Group Interfaces
By default, the SSG 20 device has Ethernet interfaces ethernet0/2—ethernet0/4
grouped together in the Trust security zone. Grouping interfaces sets interfaces in
one subnet. You can unset an interface from a group and assign it to a different
security zone. Interfaces must be in the Null security zone before they can be
assigned to a group. To place a grouped interface in the Null security zone, use the
unset interface interface port interface CLI command.
The SSG 20-WLAN devices allow Ethernet and wireless interfaces to be grouped
under one subnet.
To configure a group with Ethernet and wireless interfaces, do the following:
unset interface bgroup0 port ethernet0/3
unset interface bgroup0 port ethernet0/4
set interface bgroup1 port ethernet0/3
set interface bgroup1 port ethernet0/4
set interface bgroup1 port wireless0/2
set interface bgroup1 zone DMZ
set interface bgroup1 ip 10.0.0.1/24
save
NOTE: Only wireless and Ethernet interfaces can be set in a bridge group.