Juniper SSG 20-WLA, Hardware Installation And Configuration Manual

Page: 22 / 82

SSG 20 Hardware Installation and Configuration Guide
12 „
Equipment Rack Installation
„ Do not place the device in an equipment rack frame that blocks an intake or
exhaust port. Ensure that enclosed racks have fans and louvered sides.
„ Correct these hazardous conditions before any installation: moist or wet floors,
leaks, ungrounded or frayed power cables, or missing safety grounds.
Equipment Rack Installation
You can front-mount an SSG 20 device into a standard 19-inch equipment rack. The
device is shipped with mounting brackets installed.
To front-mount an SSG 20 device, you need a number 2 phillips screwdriver (not
provided) and four screws that are compatible with the equipment rack (not
provided).
To install an SSG 20 device onto a rack:
1. Align the rack mount ears to the device.
2. Place the screws in the holes and use a phillips screwdriver to secure them.
3. Mount the device on the rack with the provided screws.
4. Plug the power supply into the power outlet.
Connecting the Interface Cable to a Device
To connect the interface cable to a device, perform the following steps:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable-connector port on the interface
faceplate.
3. Arrange the cable as follows to prevent it from dislodging or developing stress
points:
a. Secure the cable so that it is not supporting its own weight as it hangs to
the floor.
b. Place any excess cable out of the way in a neatly coiled loop.
c. Use fasteners to maintain the shape of the cable loops.