Juniper SRX5600, Hardware Manual

Page: 271 / 483

7. Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
8. Grasp the ejector handles and slide the SCB about halfway out of the chassis.
9. Place one hand underneath the SCB to support it and slide it completely out of the chassis.
10. Place the SCB on the antistatic mat.
11. If you are not replacing the SCB now, install a blank panel over the empty slot.
Figure 121: Removing an SCB
OK
MASTER
FAN
ONLINE
OFFLINE
0
1
1
0
FAIL
FAIL
PEM
FAIL
FAIL
FAIL
FAIL
FAIL
FAIL
ESD
OK
OK
OK
OK
OK
OK
OK
2
3
4
5
ACO/LT
YELLOW
ALARM
RED ALARM
NC NO C
NC
NO C
REO
RE1
0 1 2 3
SCB
g030247
Ejectors
SCB
STATUS
SPU0
SERVICE
STATUS
SPU1
SERVICE
HA
OK/F
AIL
CHASSIS
CLUSTER
CONTROL 0
ENABLE
LINK/ACT
CHASSIS
CLUSTER
CONTROL 1
ENABLE
LINK/ACT
STATUS
SPU0
SERVICE
STATUS
SPU1
SERVICE
HA
OK/F
AIL
CHASSIS
CLUSTER
CONTROL 0
ENABLE
LINK/ACT
CHASSIS CLUSTER
CONTROL 1
ENABLE
LINK/ACT
Installing an SRX5600 Services Gateway SCB
To install an SCB (see Figure 122 on page 276 ):
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Power off the services gateway using the command request system power-off.
user@host#
request system power-off
NOTE: Wait until a message appears on the console confirming that the services stopped.
274