Juniper SRX5600, Hardware Manual

Page: 255 / 483

Disconnecting an SRX5600 Services Gateway AC Power Supply Cord
WARNING: Before working on an AC-powered device or near power supplies, unplug
the power cord.
To disconnect the AC power cord:
1. Unplug the power cord from the power source receptacle.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
3. Move the AC switch next to the appliance inlet on the power supply to the off position (O).
4. Unplug the power cord from the appliance inlet on the power supply.
Connecting an SRX5600 Services Gateway AC Power Supply Cord
To connect the AC power cord:
1. Locate a replacement power cord with the type of plug appropriate for your geographical location.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
3. Insert the power cord plug into an external AC power source receptacle.
4. Connect the power cord to the power supply.
5. Route the power cord along the cable restraint toward the left or right corner of the chassis. If needed
to hold the power cord in place, thread plastic cable ties, which you must provide, through the openings
on the cable restraint.
6. Verify that the power cord does not block the air exhaust and access to services gateway components,
or drape where people could trip on it.
7. Switch the AC switch on the each power supply to the on position (—) and observe the status LEDs on
the power supply faceplate. If the power supply is correctly installed and functioning normally, the
AC OK and DC OK LEDs light steadily, and the PS FAIL LED is not lit.
258