Juniper SRX5600, Hardware Manual

Page: 208 / 483

Figure 92: Reinstalling the Fan Tray
Reinstalling SCBs After Installing the SRX5600 Services Gateway Without a Lift
To reinstall an SCB (see Figure 93 on page 212 ):
CAUTION: Before removing or replacing an SCB, ensure that the ejector handles are
stored horizontally and pressed toward the center of the SCB.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Carefully align the sides of the SCB with the guides inside the chassis.
3. Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
4. Grasp both ejector handles and rotate them simultaneously clockwise until the SCB is fully seated.
5. Place the ejector handles in their proper position, horizontally and toward the center of the board. To
avoid blocking the visibility of the LEDs position the ejectors over the PARK icon.
211