Juniper SRX5400, Hardware Manual, Page: 280 / 394

•
Press the online/offline button on the port module. Use a narrow-ended tool that
fits inside the opening that leads to the button. Press and hold the button until the
port module LED goes out (about 5 seconds).
•
Issue the following CLI command:
user@host>
request chassis pic fpc-slot
fpc-slot
pic-slot
port-module-slot
offline
For more information about the command, see Junos OS System Basics and Services
Command Reference at
www.juniper.net/techpubs/
.
3.
Unplug the cable from the cable connector port. If the MIC uses fiber-optic cable,
immediately cover each transceiver and the end of each cable with a rubber safety
cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Installing an SRX5400 Services Gateway Network Cable
To install a cable in a MIC:
1.
Have ready a length of the type of cable used by the MIC.
2.
If the cable connector port is covered by a rubber safety plug, remove the plug.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
3.
Insert the cable connector into the cable connector port on the faceplate.
Copyright © 2017, Juniper Networks, Inc. 254
SRX5400 Services Gateway Hardware Guide