Juniper SRX5400, Hardware Manual, Page: 231 / 394

•
Configuring Zones and Assigning Interfaces on page 206
• Configuring Security Policies on page 206
Configuring the Hostname
To configure the hostname:
1.
Launch a Web browser from the management device.
2.
Enter the IP address of the device in the URL address field.
3.
Specify the default username as root and enter the password. See “Configuring Root
Authentication and the Management Interface from the CLI” on page 203 .
4.
Click Log In . The J-Web Dashboard page appears.
5.
Select Configure>System Properties>System Identity , and then select Edit . The Edit
System Identity dialog box appears.
6.
Enter the hostname and click
OK
.
7.
Select
Commit Options>Commit
to apply the configuration changes.
You have successfully configured the hostname for the system.
Configuring Interfaces
To configure two physical interfaces:
1.
From the J-Web Dashboard page, select
Configure>Interfaces
and select a physical
interface you want to configure.
2.
Select Add>Logical Interface . The Add interface dialog box appears.
3.
Set Unit = 0 .
4.
Select the check box for IPv4 Address to enable IPv4 addressing.
5.
Click Add and enter the IPv4 address.
6.
Click OK .
A message appears after your configuration changes are validated successfully.
7.
Click
OK
.
8.
Select
Commit Options>Commit
to apply the configuration changes.
A message appears after your configuration changes are applied successfully.
9.
Click
OK
.
You have successfully configured the physical interface. Repeat these steps to configure
the second physical interface for the device.
205 Copyright © 2017, Juniper Networks, Inc.
Chapter 23: Performing the Initial Configuration