Juniper SRX5400, Hardware Manual, Page: 229 / 394

interfaces {
xe-2/0/0.0;
}
}
}
policies {
from-zone trust to-zone untrust {
policy bob {
match {
source-address any;
destination-address any;
application any;
}
then {
permit;
}
}
}
}
}
18.
Commit the configuration to activate it on the device.
[edit]
admin@#
commit
19.
Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the device.
[edit]
admin@#
commit
20.
When you have finished configuring the device, exit configuration mode.
[edit]
admin@#
exit
admin@host>
Related
Documentation
SRX5400 Services Gateway Software Configuration Overview on page 199
•
Performing Initial Software Configuration Using J-Web
•
Configuring Root Authentication and the Management Interface from the CLI on page 203
•
Configuring Interfaces, Zones, and Policies with J-Web on page 204
Configuring Root Authentication and the Management Interface from the CLI
Before you can use J-Web to configure your device, you must access the CLI to perform
the initial configuration.
To configure root authentication and the management interface:
1.
Log in as root. There is no password.
2.
Start the CLI and enter configuration mode.
root@% cli
root@> configure
203 Copyright © 2017, Juniper Networks, Inc.
Chapter 23: Performing the Initial Configuration