Juniper SRX5400, Hardware Manual, Page: 198 / 394

6.
Slide the MIC into the MPC until it is firmly seated in the MPC. The ejector knob will
automatically move in towards the faceplate to lock the MIC in position as it seats.
If the MIC does not seat properly in the slot, pull the ejector knob all the way out and
try again to seat the MIC. The MIC will not seat properly unless the ejector knob is all
the way when you start to insert the MIC.
CAUTION: Slide the MIC straight into the slot to avoid damaging the
components on the MIC.
7.
After the MIC is seated in its slot, verify that the ejector knob is engaged by pushing it
all the way in toward the MPC faceplate.
8.
If the MIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
and the end of each cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Related
Documentation
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway
•
•
Removing an SRX5400 Services Gateway MIC on page 264
•
Troubleshooting SRX5400 Services MICs on page 233
Installing an MPC and MICs in an Operating SRX5400 Services Gateway Chassis Cluster
If your services gateway is part of a chassis cluster, you can install an additional MPC in
the services gateways in the cluster without incurring downtime on your network.
Such an installation meet the following conditions:
• Each of the services gateways in the cluster has an unoccupied slot for the MPC.
• If the chassis cluster is operating in active-active mode, you must transition it to
active-passive mode before using this procedure. You transition the cluster to
active-passive mode by making one node primary for all redundancy groups.
• Both of the services gateways in the cluster must be running Junos OS Release
12.1X45-D10 or later.
If your installation does not meet these criteria, use the procedure in “Installing an
SRX5400 Services Gateway MPC” on page 169 to install MPCs in your services gateway.
Copyright © 2017, Juniper Networks, Inc. 172
SRX5400 Services Gateway Hardware Guide