Juniper SRX4200, Hardware Manual

Page: 52 / 100

user@host>file list /etc/config
3.
View the required default config file.
user@host> file show /etc/config/<config file name>
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. If the current active configuration fails, you can use
the
load factory-default
command to revert to the factory-default configuration.
Configuring the SRX4200 Services Gateway
This procedure explains how you can create an initial configuration using CLI commands
to connect the services gateway to the network.
NOTE: Before you can use J-Web to configure your services gateway, you
must access the CLI to configure the root authentication.
1.
Connect the RJ-45 end of the DB9-to-RJ-45 cable into the CONSOLE port on your
services gateway.
2.
Connect the other end of the cable to the serial port on the management device.
3.
Log in to the services gateway as root. When the services gateway is powered on with
the factory-default configuration, you do not need to enter a password.
4.
At the ( % ) prompt, type cli to start the CLI and press Enter. The prompt changes to
an angle bracket ( > ) when you enter CLI operational mode.
root%
cli
root>
5.
At the ( > ) prompt, type configure and press Enter. The prompt changes from > to #
when you enter configuration mode.
root> configure
Entering configuration mode
[edit]
root#
6.
Set the root authentication password by entering a cleartext password, an encrypted
password, or an SSH public key string (DSA or RSA).
[edit]
Copyright © 2019, Juniper Networks, Inc. 52
SRX4200 Services Gateway Hardware Guide