Juniper SRX1500, Hardware Manual

Page: 93 / 168

Configuring Interfaces
To configure two physical interfaces:
1.
From the J-Web Dashboard page, select
Configure>Interfaces
and select a physical
interface you want to configure.
2.
Select
Add>Logical Interface
. The Add interface dialog box appears.
3.
Set Unit = 0 .
4.
Select the check box for
IPv4 Address
to enable IPv4 addressing.
5.
Click Add and enter the IPv4 address.
6.
Click
OK
.
A message appears after your configuration changes are validated successfully.
7.
Click OK .
8.
Select
Commit Options>Commit
to apply the configuration changes.
A message appears after your configuration changes are applied successfully.
9.
Click
OK
.
You have successfully configured the physical interface. Repeat these steps to configure
the second physical interface for the device.
Configuring Zones and Assigning Interfaces
To assign interfaces within a trust zone and an untrust zone:
1.
From the J-Web Dashboard page, select
Configure>Security>Zones/Screens
and click
Add
. The Add Zone dialog box appears.
2.
In the Main tab, enter trust for zone name and enter the description.
3.
Set the zone type to
Security
.
4.
Select the interfaces listed under Available and move them under Selected.
5.
Click OK .
A message appears after your configuration changes are validated successfully.
75 Copyright © 2017, Juniper Networks, Inc.
Chapter 17: Performing the Initial Configuration