
Part Type Tag Current Available Status
version version
FPC 2
PIC 0 MWAP_FW 1 1.2.1 1.2.1 OK
Routing Engine 0 RE BIOS 0 3.0 3.6 OK
Routing Engine 0 RE BIOS Backup 1 3.0 3.6 OK
The device reboots after the firmware is upgraded. Note that if you issue the show system firmware command after
the reboot, the Current Version field shows the latest firmware version and the Available Version field shows zero(0).
Regulatory and Safety Information for the Wi-Fi Mini-PIM
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
33