Juniper SRX 5800, Hardware Manual

Page: 335 / 536

Table 68: List of Interface Cards for Upgrade
Replacement Cards for Upgrade Cards to Replace
SRX5K-MPC and MICs SRX5K-40GE-SFP
SRX5K-MPC and MICs SRX5K-4XGE-XFP
SRX5K-MPC and MICs SRX5K-FPC-IOC
SRX5K-RE-1800X4 SRX5K-RE-13-20
SRX5K-SCBE SRX5K-SCB
SRX5K-SCB3 SRX5K-SCBE
•
Verify that both services gateways in the cluster are running the same Junos OS versions; release
12.1X47-D15 or later for SRX5K-SCBE with SRX5K-RE-1800X4 and 15.1X49-D10 or later for
SRX5K-SCB3 with SRX5K-RE-1800X4. For more information on cards supported on the services gateways
see “Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways” on page 99 .
For more information about unified in-service software upgrade (unified ISSU), see Upgrading Both
Devices in a Chassis Cluster Using an ISSU .
To perform an ISHU:
1. Export the configuration information from the secondary node to a USB or an external storage device.
For more information about mounting the USB on the device, refer to KB articles KB12880 and KB12022
from the Knowledge Base .
2. Power off the secondary node.
See, Powering Off the SRX5400 Services Gateway, Powering Off the SRX5600 Services Gateway, or
“Powering Off the SRX5800 Services Gateway” on page 249 .
3. Disconnect all the interface cards from the chassis backplane by pulling them out of the backplane by
6” to 8” (leaving cables in place).
4. Replace the SRX5K-SCBs with SRX5K-SCBEs, or SRX5K-SCBEs with SRX5K-SCB3s and
SRX5K-RE-13-20s with SRX5K-RE-1800X4s based on the chassis specifications.
5. Power on the secondary node.
See:
336