Juniper NetScreen 5GT Wireless, User Manual, Page: 21 / 40

ADSL Configuration
NetScreen-5GT Wireless 19
ADSL C
ONFIGURATION
This section describes the default settings and operation of the NetScreen-5GT Wireless
ADSL Annex A and B devices as they are shipped from the factory. These default settings
are such that, in most cases, there are only a few items that you must configure.
This section describes the following configurations for the Untrust zone interface:
• Configuring the ADSL Interface
• VPI/VCI and Multiplexing Method
• PPPoE or PPPoA
• Annex B Mode
• Configuring a Backup Untrust Zone Interface
• Static IP Address and Netmask
The figure below shows the default configuration for the NetScreen-5GT Wireless ADSL.
The ADSL interface has the predefined name “adsl1” and is the main connection from
your network to the Internet. To allow the NetScreen device (and the devices on your
network) to connect to the Internet, you must configure the adsl1 interface according to
information obtained from your service provider. Refer to
“Configuring the ADSL
Interface” on page 20 .
Note: If you have any problems completing a configuration and you need to restore the
device to its default settings, see
“Resetting the Device to Factory Defaults” on page 29 .
Trust Interface
192.168.1.1/24
To Internet
Telephone
Outlet
Hub
ADSL Interface
(adsl1)
wireless2 Interface
192.168.2.1/24
wireless1 interface
Trust Zone
Wzone1