Juniper MX480, Hardware Manual, Page: 346 / 420

Remove the MX480 Routing Engine
1.
Remove the cables connected to the Routing Engine.
2.
Place an electrostatic bag or antistatic mat on a flat, stable surface.
3.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
4.
Loosen the captive screws on the top and bottom of the Routing Engine.
5.
Flip the ejector handles outward to unseat the Routing Engine.
6.
Grasp the Routing Engine by the ejector handles, and slide it about halfway out of the
chassis.
7.
Place one hand underneath the Routing Engine to support it, and slide it completely
out of the chassis.
8.
Place the Routing Engine on the antistatic mat.
Install the MX480 Routing Engine into the SCBE2-MX
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2.
Ensure that the ejector handles are not in the locked position. If necessary, flip the
ejector handles outward.
3.
Place one hand underneath the Routing Engine to support it.
4.
Carefully align the sides of the Routing Engine with the guides inside the opening on
the SCBE2-MX.
5.
Slide the Routing Engine into the SCBE2-MX until you feel resistance and then press
the faceplate of the Routing Engine until it engages the connectors.
6.
Press both of the ejector handles inward to seat the Routing Engine.
7.
Tighten the captive screws on the top and bottom of the Routing Engine.
8.
Connect the management device cables to the Routing Engine.
Copyright © 2019, Juniper Networks, Inc. 346
MX480 Universal Routing Platform Hardware Guide