Figure 64: Installing the Router in the Rack
NOTE:
This illustration depicts the router being installed in an open-frame
rack.
Reinstalling Components in the MX480 Router After Installing It Without a Lift
After the router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
1.
Reinstalling the Power Supplies After Installing the MX480 Router Without a
Lift on page 198
2.
Reinstalling the Fan Tray After Installing the MX480 Router Without a Lift on page 198
3.
Reinstalling the SCBs After Installing the MX480 Router Without a Lift on page 199
4.
Reinstalling the DPCs After Installing the MX480 Router Without a Lift on page 200
5.
Reinstalling the FPCs After Installing the MX480 Router Without a Lift on page 201
197
Copyright © 2019, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration
Summary of Contents for MX480
