Juniper MX480, Hardware Manual

Page: 177 / 420

Figure 47: Installing the Mounting Hardware for an Open-Frame Rack
Moving the Mounting Brackets for Center-Mounting the MX480 Router
Two removable mounting brackets are attached to the mounting holes closest to the
front of the chassis. You can move the pair of brackets to another position on the side of
the chassis for center-mounting the router.
To move the mounting brackets from the front of the chassis toward the center of the
chassis:
1.
Remove the three screws at the top and center of the bracket.
2.
Pull the top of the bracket slightly away from the chassis. The bottom of the bracket
contains a tab that inserts into a slot in the chassis.
3.
Pull the bracket away from the chassis so that the tab is removed from the chassis
slot.
4.
Insert the bracket tab into the slot in the bottom center of the chassis.
5.
Align the bracket with the two mounting holes located toward the top center of the
chassis.
There is no mounting hole in the center of the chassis that corresponds to the hole in
the center of the bracket.
177 Copyright © 2019, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration