Juniper MX2010, Hardware Manual

Page: 555 / 825

SEE ALSO
Maintaining the MX2010 SFB | 680
Installing an MX2000 SFB | 394
Installing an MX2000 SFB
To install an SFB (see Figure 184 on page 395 ):
CAUTION: Before removing or replacing an SFB, ensure that the ejector handles are
stored horizontally and pressed toward the center of the SFB.
CAUTION: If one of the SFBs fails, do not remove the failed SFB until you have a
replacement or blank panel to install.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each SFB to be installed out of its electrostatic bag, and identify the slot on the SFB where it will
be connected.
3. Carefully align the sides of the SFB with the guides inside the chassis.
4. Slide the SFB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
5. Place the ejector handles in their proper position, vertically and toward the center of the board.
539