Table 13: Power Supply Overview
JNP10K-PWR-DC2
JNP10K-PWR-DC
JNP10K-PWR-AC2
JNP10K-PWR-AC
5500 W when set for
high power (80-A) or
4400 W when set for
low power (60-A)
2500 W
5000 W or 5500 W
when set for high power
(30-A); 3000 W when
set for low power (20-A)
2700 W
Maximum
output power
4 (INPUT 1, INPUT 2)
2 (INPUT 1, INPUT
2)
2 (INP1, INP2)
2 (INP1, INP2)
Inputs
Standard or enhanced*
Standard
Standard or enhanced*
Standard
Compatible
power bus
Note:
*JNP10K-PWR-AC2 and JNP10K-PWR-DC2 models can use the standard bus. The available power is 3000 W for
power budget from the power management software.
JNP10K-PWR-AC Power Supply
The JNP10K-PWR-AC power supplies are hot-insertable, hot-removable, field-replaceable units (FRUs).
In an MX10016, you can install up to 10 power supplies in the slots labeled PSU 0 through PSU 9. You
can install the power supplies in any slot.
The JNP10K-PWR-AC power supplies are 2700-W and support 200–240 VAC. The output is 12 VDC;
the output power is 2700 W.
The AC power supply supports 200–240 VAC. The output is 12 VDC; the output power is 2700 W.
CAUTION:
Do not mix AC and DC power supplies in the same chassis. AC and HVAC
can coexist in the same chassis during the hot swap of AC for HVAC. Do not mix AC and
HVAC power supplies in a running environment.
WARNING:
The router is pluggable type A equipment installed in a restricted-access
location. It has a separate protective earthing terminal on the chassis that must be
connected to earth ground permanently to ground the chassis adequately and protect
the operator from electrical hazards.
58
Summary of Contents for MX10016
