Juniper Mesa Pro, User Manual

Page: 20 / 76

20
Mesa Pro Rugged Tablet User’s Manual
■ The AC wall charger is plugged in and the batteries are full
(not charging).
Red LED, blinking:
■ The AC wall charger is plugged in and the batteries are in the
process of charging.
White light:
■ Front facing camera is in use.
Green LED, solid:
■ Does not have an assigned function, but it can be
programmed as desired.
Blue LED, solid or blinking:
■ Does not have an assigned function, but it can be
programmed as desired.
Note: These LEDs can be programmed by a developer. Sample
code is available upon request.
2.5 Light Sensor
All units have an ambient light sensor located on the front of the
Mesa Pro in the upper-right corner. The light sensor allows the
backlight on the display to adjust automatically when the lighting
changes.
To enable this process, go to the Start menu and select
Settings
>
System
>
Display
>
Brightness
. Check “Change brightness
automatically when lighting changes.”
2.6 I/O Connector Ports
The Mesa Pro has a 19 V DC power input jack, two USB 3.1 Gen 2,
one USB-C, and a 3.5 mm audio jack.
2.6.1 I/O Port Cover
The I/O Port Cover is removable and replaceable. If you need a
new rubber cover, contact your sales representative.
1. Unscrew the rubber I/O cover from the back of the Mesa Pro
with a Torx T6 screwdriver.