Juniper LN1000-V, Hardware Manual

Page: 50 / 56

Routing Engine REV 06 710-027379 DY7841 LN1000-V
FPC 0 FPC
PIC 0 8x GE Base PIC
Xcvr 0 REV 01 740-026948 UFA03J9 SFP-T
Xcvr 1 REV 01 740-026948 UFA03L0 SFP-T
Xcvr 2 REV 01 740-027085 UFA03UW SFP-T
Xcvr 3 REV 01 740-011782 PB82D10 SFP-SX
Xcvr 4 REV 01 740-011782 PB82D13 SFP-SX
Xcvr 5 REV 01 740-011613 AM0819S9RPK SFP-SX
Xcvr 6 REV 01 740-011613 AM0821SA1UL SFP-SX
Xcvr 7 REV 01 740-011613 AM0819S9RPC SFP-SX
Power Supply 0
Removing an SFP from an LN1000–V RTM
WARNING: Do not look directly into transceivers or into the ends of fiber-optic cables
connected to a transceiver. Fiber-optic transceivers emit laser light that can damage
your eyes.
CAUTION:
When handling fiber-optic transceivers and fiber-optic cable, observe the following
precautions:
•
Do not leave a fiber-optic transceiver uncovered except when inserting or removing
cable. The safety cap keeps the port clean and prevents accidental exposure to laser
light.
•
Do not bend fiber-optic cable beyond its minimum bend radius. An arc smaller than
a few inches in diameter can damage the cable and cause problems that are difficult
to diagnose.
• Do not let fiber-optic cable hang free from the connector. Do not allow fastened loops
of cable to dangle, which stresses the cable at the fastening point.
Figure 10: Small Form-Factor Pluggable (SFP)
g001855
Connector
Locking pin
Copyright © 2010, Juniper Networks, Inc. 32
LN1000-V Mobile Secure Router Hardware Guide