Juniper LN1000-V, Hardware Manual

Page: 42 / 56

Figure 6: LN1000-V Rear Transition Module — Back View
g017380
Connector IPMI Shelf Manager
LN1000–V Rear Transition Module Console Ports
The shMM console port is the console port for the optional shMM module on the RTM.
The settings are baud rate of 19200 8N1, no flow control. You can use this port to send
and receive debug console commands to and from the shelf manager.
The IPMC console port is the console port for the IPMC controller on the LN1000-V board.
The settings are baud rate of 115200 8N1, no flow control. This is a debug output only
port.
The RS-232 console port, labeled NPU, accepts an RJ-45 connector and is located on
the front panel of the LN1000-V rear transition module. The settings are baud rate of
9600 8N1, no flow control. You can use this console port to monitor system startup and
for system repair. This console port is also available from the front panel of the LN1000-V
router. See “Router Console Port” on page 4 for more information.
Figure 7: LN1000-V Rear Transition Module — Front Panel
g017379
Ejector latch Ejector latch ShMM IPMC NPU
ACT LINK PWR OK
Ethernet ports
USB port
0 2 3 5 6 7 4 1
Locking screw Locking screw
Table 5: Pinouts for the RJ-45 (NPU), shMM, and IPMC Console Port Connectors
Description Setting Pin
No connect. NC 1
Transmit data into the LN1000–V router. RXD 2
Transmit data out from the LN1000–V router. TXD 3
No connect. NC 4
Ground. GND 5
Copyright © 2010, Juniper Networks, Inc. 24
LN1000-V Mobile Secure Router Hardware Guide