Juniper JRR200, Hardware Manual

Page: 66 / 108

Table 23: Alarms for JRR200 Route Reflector Chassis Components
Alarm Severity Action Alarm Conditions Component
Steady red (major) • Check and adjust the room
temperature, if possible.
• Check the air flow and ensure
that the airflow through JRR200
route reflector is unobstructed.
• Replace the failed fan tray to
avoid failure of the other fan
trays.
• Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
At least one of the fans have
failed. Fan
Yellow (minor)/Red
(major) • Check the room temperature.
• Check the air flow.
• Run all the Fans at full speed.
• Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
The JRR200 route reflector
chassis temperature is too
warm.
Red (major) Install the missing fan tray. Missing fan tray
Yellow (minor) • Check if the fan is spinning more
than the configured speed.
• Replace the fan tray as it is likely
to fail.
Fan over-speeding
Yellow (minor)
•
Check if the fan is spinning below
the configured speed.
• Replace the fan tray as it is likely
to fail.
Fan spinning below its speed
Yellow (minor) Replace the fan tray. Impeding fan failure
Copyright © 2018, Juniper Networks, Inc. 66
JRR200 Route Reflector Hardware Guide