Juniper JRR200, Hardware Manual

Page: 50 / 108

root#
set interfaces em0 unit 0 family inet address address/prefix-length
c. Commit the configuration changes.
root#
commit
d. Configure an IP address for the management device. Ensure that the IP address is
on the same subnetwork as the management interface (
em0
).
9.
When you have finished configuring the device, exit configuration mode:
[edit]
root#
exit
JRR200 Route Reflector Factory-Default Settings
Your JRR200 route reflector comes configured with a factory-default configuration which
has the ZTP configurations enabled when the JRR200 route reflector is shipped.
The below is the factory default configuration file of JRR200 route reflector.
interfaces {
em0 {
unit 0 {
family inet {
dhcp;
}
}
}
}
interfaces {
em2 {
unit 0 {
family inet {
dhcp;
}
}
}
}
interfaces {
em3 {
unit 0 {
family inet {
dhcp;
}
}
}
}
interfaces {
em4 {
unit 0 {
family inet {
dhcp;
}
}
Copyright © 2018, Juniper Networks, Inc. 50
JRR200 Route Reflector Hardware Guide