Juniper Advanced Threat Prevention Appliance, Cli Command Reference Manual, Page: 111 / 120

CLI Command Reference Guide
Copyright© 2018, Juniper Networks, Inc. 103
setupcheck
Syntax
# set traffic-monitoring-ifc 1gb_ifc
Set the traffic monitoring interface to be the 1G interface.
# set traffic-monitoring-ifc 10gb_ifc
Set the traffic monitoring interface to be the 10G interface.
NOTE After making an interface type change, the system must be rebooted
for the change to take effect.
Table 5-22 setupcheck
Description Checks and reports on basic configuration settings and analysis pipeline setup.
Product(s) CLI All-in-One | Core CM | Mac Mini OS X Detection Engine
Mode(s) diagnosis
Syntax
setupcheck {all | report | basic | analysis}
Parameters
Example
The following example checks all basic configuration settings as well as the
analysis pipeline:
JATP (diagnosis) # setupcheck all
Table 5-21 set traffic-monitoring
all
Checks both basic settings and analysis
pipeline.
report
Shows report of last setupcheck.
basic
Checks basic configuration settings.
analysis
Checks the analysis pipeline.