6.9.2
Releasing and applying the load wheel brake
Z
The load wheel brakes are fitted only on the ETX 515.
WARNING!
Uncontrolled truck movement
When the brakes are de-activated the truck must be parked on a level surface, since
the brakes are no longer effective.
u
Do not release the brake on slopes or inclines.
u
Apply the brake again when you reach your destination.
u
Do not park the truck with the brake released.
95
8
9
183
24
181
181
182
Releasing the load wheel brake
Requirements
– Fully lower the mast, see page 168 or see page 201.
– Traverse the attachment to the home position (
t
– Traverse the telescopic table to the centre position (
o
– Disconnect the battery.
Tools and Material Required
– Six setscrews (Allen screws). The setscrews are supplied with the truck.
– Allen key (key width 6).
Procedure
• Release the drive wheel brake, see page 215.
• Switch off the truck, to do this:
• Turn the key in the key switch (8) left as far as the stop and remove the key.
• Press the red button on the ISM access module (
o
).
• Press the Emergency Disconnect (9).
219
04.19 en-GB
Summary of Contents for ETX 513
