Jungheinrich ESD 220, Operating Instructions Manual

Page: 62 / 186

2.1 Battery discharge indicator
When the truck has been released via the key
switch, CanCode or ISM, the battery charge status
is displayed. The LED colours (62) represent the
following conditions:
LED colour Charge status
Green 40–100%
Orange 30–40%
Green/orange
flashes at 1 Hz
20–30%
Red 0–20%
Z
If the LED is red, the load can no longer be lifted. Lifting is only enabled when the
battery connected is at least 70% charged.
If the LED flashes red and the truck is not ready for operation, inform the
manufacturer's service department. Red flashing is a truck controller code. The
flashing sequence indicates the type of fault.
2.2 Battery discharge monitor
Z
Die serienmäßige Einstellung des Batterieentladewächters erfolgt auf
Standardbatterien. When using maintenance-free batteries or special batteries, the
display and cut-off points of the battery discharge monitor must be set by the
manufacturer's customer service department. If this setting is not configured, the
battery may be damaged due to deep discharge.
If the residual capacity falls below the required level, lifting is inhibited. An
corresponding display appears. Lifting is only released when the battery connected
is at least 70% charged.
62
60
10.19 en-GB