Jungheinrich ESD 220, Operating Instructions Manual

Page: 103 / 186

8.4.2 Preparing the truck for operation with the keypad (CanCode)
Preparing the truck for operation by entering a valid operator code
Procedure
• Pull the Emergency Disconnect to unlock it, see page 73.
The LED (92) lights up red.
• Enter the operator code with the digit keys.
When you have entered a valid operator code the LED (92) lights up green, the
travel program selected is indicated by the corresponding LEDs (88,89,90) and
the truck is switched on.
Z
If the LED (92) flashes red this means the wrong code has been entered. Enter
the code again.
The Set key (91) has no function in operating mode.
8.4.3 Switching off the truck with the keypad (CanCode)
Switching off the truck
Procedure
• Press the O key (93).
The truck is switched off and the LED (92) is lit red.
Z
The truck can cut out automatically after a specified time. If no travel, steering or
hydraulic operations are performed within a set time, the truck switches off
automatically. When you enter a valid code again the truck will be operational. The
code lock parameter responsible for automatic cutout must be set, see page 112.
101
10.19 en-GB