Jungheinrich EJC M10, Operating Instructions Manual

Page: 42 / 73

E 13
0
509
.GB
7.1 Service hours display
Display range between 0.0 and 99,999.0 hours. Travel and lifting operations are
logged. This is a backlit display.
For maintenance-free batteries a “T” symbol is shown in the service hours
display (19).
Eventmessages
The service hours display is also used to display events. The event display starts with
an "E" for error and a three digit error number.
If several events occur simultaneously, they are displayed one after the other. The
events are displayed until they are rectified. Event messages overwrite the service
hour display. Most events cause the emergency stop to be activated. The event
display remains until the control circuit is switched off (key switch).
If no CanDis is present, the event code is displayed by the flashing of the charge/
discharge indicator LED.
Z
The manufacturer’s service department has detailed component descriptions with
event codes.
7.2 Power up test
On power up the display shows:
– the software version of the display instrument (briefly),
– the service hours,
– the charge status.
E 13
0
509
.GB
7.1 Service hours display
Display range between 0.0 and 99,999.0 hours. Travel and lifting operations are
logged. This is a backlit display.
For maintenance-free batteries a “T” symbol is shown in the service hours
display (19).
Eventmessages
The service hours display is also used to display events. The event display starts with
an "E" for error and a three digit error number.
If several events occur simultaneously, they are displayed one after the other. The
events are displayed until they are rectified. Event messages overwrite the service
hour display. Most events cause the emergency stop to be activated. The event
display remains until the control circuit is switched off (key switch).
If no CanDis is present, the event code is displayed by the flashing of the charge/
discharge indicator LED.
Z
The manufacturer’s service department has detailed component descriptions with
event codes.
7.2 Power up test
On power up the display shows:
– the software version of the display instrument (briefly),
– the service hours,
– the charge status.