Jungheinrich EJC 212z, Operating Instructions Manual

Page: 42 / 250

5.4 Wind loads
Wind forces can affect the stability of a truck when lifting, lowering and transporting
loads with large surface areas.
Light loads must be especially secured when they are subjected to wind forces. This
will prevent the load from sliding or falling.
Stop the truck in both cases.
5.5 Capacity Plate for Stacking and Transport Operations
Z
EJC 212z / 214z / 216z / 220z only
Z
Not for double-decker option
The "stacking and transport operations" capacity plate (28) specifies the capacity (Q
in kg) of the truck during stacking and transport operations:
28
A B
A= Stacking operations (storing and retrieving loads):
During high-level lift (mast lift) observe the capacity depending on the lift
height, see page 37.
B= Transport operations:
Max. capacity when transporting loads horizontally 2000 kg with the support
arms raised and without high-level lift (mast lift).
Z
During stacking operations with the low-level lift (support arm lift) raised, loads can
be stored and retrieved up to a lift height of 1800 mm. For lift heights above
1800 mm the low-level lift (support arm lift) must be lowered.
Z
Do not transport loads when they are raised (>500 mm).
40
04.19 en-GB